|
1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465 |
- # For more options and information see
- # http://rpf.io/configtxt
- # Some settings may impact device functionality. See link above for details
-
- # uncomment if you get no picture on HDMI for a default "safe" mode
- #hdmi_safe=1
-
- # uncomment this if your display has a black border of unused pixels visible
- # and your display can output without overscan
- #disable_overscan=1
-
- # uncomment the following to adjust overscan. Use positive numbers if console
- # goes off screen, and negative if there is too much border
- #overscan_left=16
- #overscan_right=16
- #overscan_top=16
- #overscan_bottom=16
-
- # uncomment to force a console size. By default it will be display's size minus
- # overscan.
- #framebuffer_width=1920
- #framebuffer_height=1080
-
- # uncomment if hdmi display is not detected and composite is being output
- #hdmi_force_hotplug=1
-
- # uncomment to force a specific HDMI mode (this will force VGA)
- #hdmi_group=1
- #hdmi_mode=1
-
- # uncomment to force a HDMI mode rather than DVI. This can make audio work in
- # DMT (computer monitor) modes
- #hdmi_drive=2
-
- # uncomment to increase signal to HDMI, if you have interference, blanking, or
- # no display
- #config_hdmi_boost=4
-
- # uncomment for composite PAL
- #sdtv_mode=2
-
- #uncomment to overclock the arm. 700 MHz is the default.
- #arm_freq=800
-
- # Uncomment some or all of these to enable the optional hardware interfaces
- #dtparam=i2c_arm=on
- #dtparam=i2s=on
- #dtparam=spi=on
-
- # Uncomment this to enable infrared communication.
- #dtoverlay=gpio-ir,gpio_pin=17
- #dtoverlay=gpio-ir-tx,gpio_pin=18
-
- # Additional overlays and parameters are documented /boot/overlays/README
-
- # Enable audio (loads snd_bcm2835)
- dtparam=audio=on
-
- [pi4]
- # Enable DRM VC4 V3D driver on top of the dispmanx display stack
- dtoverlay=vc4-fkms-v3d
- max_framebuffers=2
-
- [all]
- #dtoverlay=vc4-fkms-v3d
|